-40%
Magnum Venus Products – MVP High Volume Epoxy or Resin Univ Proportioning System
$ 7893.6
- Description
- Size Guide
Description
Magnum Venus Products – MVP High Volume Epoxy or Resin Universal Proportioning SystemPLEASE CALL JIM FOR MORE INFO 7146121480
Universal Proportioner System
Covers a wide application range for epoxy and urethane laminating resins and coatings
The Universal Proportioner System covers a wide application range for epoxy and urethane laminating resin and coatings. The air motor drives a heavy duty rocker arm linkage drive which drives two double acting reciprocating piston pumps. The resin side is fixed and the hardener side is adjustable, using an upper and lower screw/clamp block to set the ratio range.
Depending on desired flow rates and ratios, a series of fluid sections and dispense guns are available to fit your needs. The stainless steel fluid section series includes perfluoroelastomer soft seats which are ideal for improved metering with very low viscosity hardeners.
The UPLS-1000 fluid section alone has an output range of over 4 gallons (15.14 liters) at 40 cycles per minute. Paired with the UPLS-4600 hardener fluid section, for example, and set at a 3:1 ratio, would total 5.4 gallons (20.44 liters) per minute.
Standard on most systems is the user-friendly Pro Recirculation Gun. This allows an easy way to purge air out of the system during material container change, ratio checks, shut-down and start-up procedures with no material waste. The High-Volume Automatic 1:1 Pro Gun is also ideal to use with this system. The stainless steel head with hardened 440 stainless steel valve rod comes standard with a new glass filled Teflon valve rod seals. For lower flow rates, and applications that require a hand held gun, we recommend the classic 1:1 Pro Gun.
UNIVERSAL PROPORTIONER SYSTEM
Fluid sections:
UPLS-1000: 23.51 C.I./Cycle hardened seats or stainless steel
UPLS-4600: 9.67 C.I. /Cycle hardened seats or stainless steel
UPLS-2300: 4.82 C.I./Cycle stainless steel only
UPLS-2400: 4.95 C.I./Cycle hardened cylinder only
Note: UPLS-2400 is used only with another UPLS-2400, and is for Urethane resin systems with an added special cartridge packing configuration.
Ratio:
With two of the same fluid section listed above: 1:1 to 3.1:1 by volume
UPLS-1000 & UPLS-4600: 2.43:1 to 7.5:1
UPLS-1000 & UPLS-2300: 4.8:1 to 15:1
UPLS-4600 & UPLS-2300: 2:1 to 6:1
Powerhead:
At 100 psi supply air, run at 60 psi, 40 cycle/min.
10” – 72 SCFM 7” – 37 SCFM 5” – 25 SCFM
Options:
Pneumatic shot size control
Heaters and heated hoses
Auto Level Control
Flow meters
Gravity feed containers
Pressure feed pumps
Innovator Plus PLC Control Box